Specifications include, but are not limited to: External Armor Carrier X 60 The foundation of the External Armor Carrier is constructed from an outer layer of 1000 denier polyurethane coated CORDURA® Nylon fabric, and an inner lining of 100% polyester 7.9 ounce military 3D AMY/SORBTEK spacer mesh fabric featuring antimicrobial and permanent moisture management properties. Construction of the armor carrier foundation will be based on a physical tracing of the individual officer’s body armor panels paired with body measurements from each officer. Consideration will be given to ensure that the pockets sewn to the carrier fit the vest correctly. If an officer’s size or frame does not accommodate the pocket design, changes to the vest design will be preapproved by the officer and/or department. The entire carrier is edge bound with Condition “R” Mil-W-27265, Type 1A, Class 1A, three quarter inch wide nylon webbing. This procedure effectively reinforces and binds the carrier foundation, leaving no unfinished edges exposed.