Specifications include, but are not limited to: 1.1 Location 1: Teague Address: 5820 Teague Rd, Houston, TX 77041 Tower Light Model: TWR E2-3DBSL The tower is 480’ and needs the top daytime beacon bulb replaced, inspected, or replaced. Tower Crew will follow all lock out tagout procedures and have a safety climber and rescue plan in place. Climber shall climb to the top of the tower and conduct necessary repairs to the top tower beacon. Contractor MUST have some experience in inspecting, troubleshooting and repairing tower lights. 1.2 Location 2: Water Tank Mustang Trail Address: 1100 Mustang Trail, Kingwood, TX 77339 Antenna Model: SC412-HF2LDF (E5765) QTY: 2 Scope of Work: The tower is 165’ and needs the Received Antennas replaced. Tower Crew will follow all lock out tagout procedures and have a safety climber and rescue plan in place. Climber shall climb to the top of the tower and replace the two receive antennas and inspect, antennas jumper cables and repair and replace as necessary. Contractor MUST have some experience in troubleshooting, inspecting and replacing tower mounted antenna. 1.3 Location 3: East Side Water Plant Address: 2418 Federal Road, Houston, TX 77015 Tower Light Model: TWR E1-1DBSL Scope of Work: The tower is 300’ and needs the Side Marker Lights inspected, replaced, or repaired. Tower Crew will follow all lock out tagout procedures and have a safety climber and rescue plan in place. Climber shall climb to the Side Marker Light and conduct work. Contractor MUST have some experience in inspecting, troubleshooting and repairing tower lights. 1.4 Location 4&5: 7101 Renwick Drive Houston TX 77061 and 10602 Braewick Drive Houston TX 77096. Scheduling hours are Monday-Friday 7am-4pm The microwave path between 7101 Renwick Dr and 10602 Braewick Dr is showing a low RSL alarm (Receive Signal Level).To have a tower crew climb the tower and align the microwave antenna to engineered specification. The Receive Signal Level (RSL) must meet engineering specification and the restore path meet six (6) 9s performance. Contractor must have experience troubleshooting, inspecting, repairing, and aligning microwave systems.