Specifications include, but are not limited to: 1. – Bally Sectional indoor walk-in freezer complete with floor panels, shall be manufactured in accordance with NSF #7 and Section 11 40 00. Overall size of the freezer to be 9’-8” length x 8’-2 ¾ wide x 7’-6” high complete with 4” ceiling panels. 2. - 4” foam core panels shall be Underwriters Laboratories-listed as having flame spread of 25 or lower and smoke generation of 450 or lower when tested in accordance with ASTME-84-76. Panels shall be approved by Factory Mutual as a Class 1 building type. They shall be manufactured with foamed in place CFC free Enovate 3000 or Solstice foam system in accordance with the 2009 Federal Energy Standards (EISA). 3. – Factory trained installation is required. All work and materials shall fall in full accordance with local and or state ordinances, and with any other prevailing rules and regulations; specifically, on outdoor boxes, the wind calculations and snow loads. Approved Manufacturers are responsible for furnishing items required by these regulations, and information should be on quotes and drawings. Any other residing specifications will be stated in the written specs by said Consultant. 4. - Panels shall consist of interior and exterior metal skins precisely foamed with steel dies and roll-form equipment and thoroughly checked with gauges for accuracy. Metal skins shall be treated on the inside surface with a bonding agent to ensure a stable adhesion with the chemical bonding agents of the urethane. The metal skins shall be placed into heated molds and liquid urethane injected between them. Urethane shall be Enovate 3000 or Solstice, foamed in place (poured, not frothed) and, when completely cured, shall bind tenaciously to metal skins to form an insulated panel. Panels shall contain 100% urethane insulation and have no internal wood or structural members between skins unless required and approved by said consultant as structural support for external accessories. To ensure tight joints, panel edges must have foamed-in-place tongue and groove with a flexible vinyl gasket foamed-in-place on the interior and exterior of all tongue edges. Gaskets shall be resistant to damage from oil, fats, water and detergents and must be NSF-approved. Gaskets shall not be stapled or glued to metal skins. 5. – Insulation shall be rigid urethane “Foamed-in-Place”. Insulation shall have a minimum R-Value of R32 for freezers. These R-values shall be determined as per Section 312 of the EISA code. For calculating the R-value of the freezer, the K-factor of the foam at 20° F. (average foam temperature) shall be used. For calculating the R-value of the cooler, the K-factor of the foam at 55° F. (average foam temperature) shall be used.