Specifications include, but are not limited to: 1. Body Dimensions: The body is 112" long, 50" high and 78" wide. It has Diamond Tread safety step side fenders with two ladders, body assist handles. Ladders and assist handles are not available on bodies with a work deck. Body has L.E.D. style stop, turn, emergency flashers and marker lights. The body has a lockable tool storage compartment measuring 83" long, 18" deep and 10" high. MUD FLAPS INCLUDED. 2. Body Insulation: The asphalt aggregate hopper and road oil tank are fully insulated with 2" industrial, high temperature 12R factor insulation encased in a double steel jacket. 3. CAPACITY: The asphalt aggregate hopper holds 4.25 cubic yards level full or 6 tons maximum load. 4. HEATING SYSTEMS: The body shall have a dry radiant heat chamber heated by 2 each 150,000 BTU retort tube propane burners with vertical exhaust stacks. The exhaust stack dampeners are electronically actuated to close when burners are off to reduce heat loss. The burners are thermostat controlled and regulated at 10 PSI. The ignition system is 12- volt DC with electronic igniter. Gas burner has a safety shut-off upon loss of flame or excessive temperature. Automatic safety shut-off when diesel pump is operating. Burner has two stages, ignites on 10 oz. pressure, operates at 10 PSI, on high burn regulated by the same thermostat as the electric heater. Thermostats will be 0/300° F. solid state. Systems using Heat Transfer Oil are not acceptable. 5. Electronic Controls: All electronic controls will be solid state shock resist ant. Thermostat for the tack oil tank is 50/200º F. Thermostat for asphalt aggregate hopper is 0/300º F. Digital with temperature read out. Thermostat for the asphalt hopper has built in high limit safety shut down switch.