Specifications include, but are not limited to: All equipment must be new. CO2 Laser System: NOTE: alternates or approved equals are allowed (Basis of specification – Manufacturer: Epilog, Model: Fusion M2 32 50 watt CO2 Laser System) • Engraving Area: 32" x 20" (812 x 508 mm) • Maximum Material Thickness: CO2: 13.5" (343 mm) (2" lens), Fiber: 12.5" (318 mm) (3" lens), Dual Source: 12.5" (318 mm) (3" lens) • Laser Wattage: CO2: 30, 40, 50, 60, 75, or 120 watts, Fiber: 30 or 50 watts, Dual source: CO2 50, 60, or 75 watts; Fiber 30 or 50 watts • Laser Source: digitally controlled, air-cooled. Laser tubes are fully modular, permanently aligned and field replaceable. • Intelligent Memory Capacity: up to 128 MB. • Air Assist: Attach an air compressor to remove heat and combustible gases from the cutting surface by directing a constant stream of compressed air across the cutting surface. • Red Dot Pointer: visual reference for locating where the laser will fire. • Relocatable Home: set a new home position by hand. • Operating Modes: Optimized raster, vector or combined modes. • Motion Control System: High-speed Brushless DC Servo Motors. • X-Axis Bearings: stainless steel • Belts: Kevlar (x-axis) and Steel Cord (y-axis) belts. • Resolution: User controlled from 75 to 1200 dpi. • Speed and Power Control: Computer or manually control speed and power in 1% increments to 100%. Vector color mapping links speed, power and focus to any RGB color. • Print Interface: 10 Base-T Ethernet or USB Connection. Compatible with Windows® XP/Vista/7/8/10. • Size (W x D x H): 52.5" x 33.75" x 40.75", (1334 x 857 x 1035 mm), 37.75" (959 mm) deep with exhaust plenum. • Dual Source: 536 lbs (243 kg) • Electrical Requirements: Auto-switching power supply accommodates 110 to 240 volts, 50 or 60 Hz, single phase. • Ventilation System: 650 CFM (1104 m3/hr) external exhaust to the outside or internal filtration system is required. There are two output ports, 4" (102 mm) in diameter.