Specifications include, but are not limited to: Approximately 1,500 feet of Belden Motor Supply Cable is required to complete the replacement. Installation will be completed by WRF staff. This shall be one (1) roll of cable at a minimum length of the measurement stated. General Description – 4-cond. Three (3) stranded tinned copper circuit conductors plus (1) ground wire with PVC insulation, XLP insulation, Overall Duofoil ® (100% coverage) plus a tinned copper braid shield (85% coverage), tinned copper drain wire, sun & oil-resistant PVC jacket. The overall application is for a Variable Frequency Drive (VFD). Physical Characteristics • Conductor(s): Three (3), 12-gauge, 65x30, TC – Tinned Copper • Ground Wire: One (1), 12-gauge, 65x30, TC – Tinned Copper, PVC Insulation • Insulation Material: XLP Cross Linked Polyolefin • Outer Shield Material: o Layer 1: Duofoil ®, Tape, Aluminum Foil-Polyester Tape o Layer 2: Braid, TC – Tinned Copper • Outer Shield Drain Wire AWG: 12-gauge, 65x30, TC – Tinned Copper • Outer Jacket Material: PVC – Polyvinyl Chloride • Overall Cable Diameter: 0.63 inch Mechanical Characteristics • Wet Temperature Range: -40°C to +90°C • Dry Temperature Range: -40°C to +90°C • Bulk Cable Weight: 250 pounds per 1,000 feet • Max. Pulling Tension: 336 pounds • Min. Bend Radius/Minor Axis: 5 inch Applicable Specifications • NEC/(UL) Specification: TC-ER, Unlisted Singles, WTTC • NEC Articles: 336 – ER • UL Specification: 600V Type CIC TC • UL Flame Test: UL1685 UL Loading Electrical Characteristics • Nominal Characteristic Impedance: 71 Ohm • Nominal Inductance: 0.197 µH per foot • Nominal Capacitance Conductor to Conductor: 26 pF per foot • Nominal Capacitance Cond. to Other Conductor & Shield: 47 pF per foot • Nominal Conductor DC Resistance @ 20°C: 1.6 Ohm per 1,000 feet • Maximum Operating Voltage – UL: 1,000 V RMS (Flexible Motor Supply Cable); 600 V RMS (NEX Type TC) • Maximum Recommended Current: 30 Amps per conductor @ 30°C (per NEC) more or less Mfr: Belden Part # 29502