9/5/18-Duplex Control Panel- 7140 - Duplex Control Pump Panel - Utility Complex Pump Station

The City of Jacksonville is seeking quotes for the following:
Duplex Pump Control Panel for Collins Heights Pump Station.  The voltage is three phase, 120/240 delta with HL, four wire. The pumps are Fairbanks Morse model 4”, D5432MV, 15 HP, 1770 RPM, 42.2 FLA.

1.  Duplex NEMA 4X Hoffman stainless steel enclosure with three point latch and inner door.  Enclosure width not to exceed 36”.
2. UL Listed Panel.
3. Main control panel circuit breaker, Square D brand
4. Main power distribution block
5. Surge protector
6. Phase Monitor
7. Four float control system logic
8. Intrinsically safe float relays
9. Lag pump time delay relay
10. Individual pump circuit breakers, square D brand
11. Individual NEMA starters with overloads and auxiliary contacts for each pump, Square D brand
12. HOA switches for each pump
13. ETMs for each pump
14. Oil tight pilot lights and switches
15. Push to test LED style pilot lights
16. Pump alternator with selector switch
17. Labels for all lights, switches, pushbuttons, relays, etc…..
18. 115 VAC circuit breakers as follows:  control power, condensation heater, GFCI receptacle, Mission Control transformer/RTU, two spare 15 amp breakers
19. Control panel condensation heater
20. GFCI receptacle, 15 amp
21. Pump over temp relays
22. All necessary relays, terminal blocks and, fuses
23. Auxiliary contacts for monitoring the following:  pump run status, Pump Over Temp, motor overload, phase failure and, high wet well alarm
24. Alarm circuitry to include the following:  alarm light (Federal Signal model no. LP3P-120R, shipped loose owner will install), alarm horn, silence button, reset button
25. Install Mission Control Wet Well Module (P/N: OP651) with current sensors and, Missions transformer (P/N: PW-429)
26. Interface wiring of Wet Well Monitoring Equipment within the Pump Control Panel.