Specifications include, but are not limited to: The Contractor shall furnish all labor, materials, equipment, and services, and perform and complete all work including all extra work directed, all as required for the delivery of SNOW & ICE REMOVAL EQUIPMENT: DUMP BODY, PLOW, WING, & GROUND SPEED CONTROL FOR SPREADER, FOR ONE VEHICLE and installation on a New 10 Wheel Cab and Chassis. DUMP BODY: - Dimensions 14 feet long, 8 feet wide, and 48 inch sides - ¼” Hardox 450 one piece floor with anti-abrasive - ¼” Hardox 450 tapered air gate- flame cut hardware with two horizontal bends - 3/16” Hardox 450 with two horizontal bends in the center, - 3/16” Hardox 450 one piece front with 45 degree front corners -Three vertical ribs on each side of body - 10” High formed long members – 3/16” domex 100 with inside gussets for strength - 42 Inch cab protector – Driver’s side front steps - Front mount telescopic hoist- 35 ton capacity - Air PTO and direct mount pump- pedestal mounted controls - Safety prop, limit cable, and back up and body raised alarm - 3/8” x 3” Steel Wear strips on top of frame - Set of front and rear mud flaps with anti sails - All lights and reflectors to meet FMVSS-108 (LED) - Body painted Highway Aluminum - Hot shift PTO for automatic transmission - D/S shovel holder - LED- pair strobes in rear post and four front LED- 404 - Back up light in rear post -Stop / Tail/ Turn lights in rear post. - D-ring center tailgate inside - Pioneer EDD1500DA (or equivalent) electric coverall w/mesh - 8” oak sideboards - Three (3) coal doors in tailgate -Slanted 2 panel tailgate with horizontal rib HYDRAULIC CONTROL: The truck will be plumbed to operate a spreader unit to be provided by the town.