Specifications include, but are not limited to: LES EQUIPMENT SPECIFICATIONS ARTICULATING (KNUCKLE) CRANE WITH GALVANIZED FLAT BED QUANTITY: One (1) DESCRIPTION: New current standard model articulating (knuckle) crane, mounted behind the rear axles, galvanized steel flat bed with steel saddle “T” boxed, pintle hitch for pulling trailers Installed on LES supplied chassis by manufacturer or LES authorized distributor DETAILS: CRANE: One (1) current new articulating (knuckle) crane mounted behind the rear axles. Crane manufactured and designed to UNI EN 12999HC1 S1 regulations Boom with four (4) hydraulic extending boom sections Minimum of 338,900 ft/lbs. rating for a four (4) section crane Crane with capacities while the main boom is articulated to 20° and the knuckle boom is in the horizontal, as measured from the center line of rotation. Minimum capacities of: 22,600 lbs. @ 15’ 7,400 lbs. @ 40’ Extendable boom sections shall be made of minimum 160,000 PSI steel plate materials with all welds continuous inside and out (no skip welds) Self-supported single stage extension cylinders with end of stroke shock absorbers that will allow for boom deflection. All cylinders to have integral holding valves. Extension cylinders with rails are NOT acceptable The crane radio remote control to have a daytime readable multi-color display on transmitter and also to be backlit for night time use. The remote shall display the current position of crane and capacities after outriggers are deployed and stable conditions have been established before lift is attempted Remote shall be waterproof There is to be a readout panel on the crane base that duplicates the readout of the transmitter and manual crane controls at the base for secondary crane operation Remote to have an additional battery and the battery charger shall be mounted inside the truck cab within easy reach of operator while standing on the ground Work light mounted to the second boom, controlled from the radio remote Continuous rotation Stabilizer deployment to be controlled by the radio remote and an amber warning light shall be affixed to the end of each stabilizer Rear stabilizer pad holders shall be mounted vertically behind the rear wheels and in conjunction with the rear mud flaps and wheel chock holders Front stabilizer pad holder shall be mounted in the horizontal positions under each horizontal under slung box on each side of bed. All four stabilizer pad holders are to be constructed out of steel and to be galvanized and to be 25” long x 25” deep x 2 ½” wide with pendulum type retainers. The horizontal holders shall be open at the rear with a center support for cleanout Full length subframe shall be in compliance with ASME B30.22 for knuckle boom cranes Hydraulic oil reservoir shall be mounted on crane with shut off valves on suction and return lines Thermostatically controlled hydraulic oil cooler to be mounted in the crane space and to be integrated into the crane management system and to adjust fan speed proportionally depending on the temperature of the oil Supply a minimum of a 11.5 ton load hook with safety latch