Specifications include, but are not limited to: 2.1.2 The contractor must provide all equipment and the maintenance/repair related to the cable television service. a. The contractor shall be responsible for installation, maintenance, and repair of all equipment and wiring up to and including the head end. The Department shall be responsible for all equipment and wiring past the head end. b. The contractor shall install the head end at the institution. 2.1.3 The contractor shall understand and agree that because the contractor was familiar with the facility and the conditions that existed prior to award of the contract, the contractor shall not be relieved of the performance of the provisions and requirements specified herein. The contractor must furnish and maintain in good repair all equipment, including, but not limited to, dishes, antennas, TVROS, modulators, amplifiers, taps, and wiring, and any other equipment necessary to perform the requirements of the contract. a. The contractor may either own or rent, at the contractor’s expense, equipment for performing the requirements of the contract. b. Any cable/wiring installed within the facility, past the head end, becomes the property of the Department once installed. c. The repair, maintenance, and replacement of contractor supplied equipment, as necessary, shall be at no cost to the Department. d. If providing a satellite service, the contractor shall supply a minimum of two (2) satellite dishes not-to-exceed forty-two inches (42”) in diameter. If the dishes are not round, the largest dimension shall not exceed forty-two inches (42”). 1) If necessary, an additional dish not to exceed forty-two inches (42”) in diameter may be utilized for the TBN Second Chance Channels. 2) The placement, method of mounting, and cable run of satellite dishes must be approved by the Department. 3) If providing satellite service and using satellite dishes forty-two inches (42”) or less, the contractor must provide heaters on the dishes with an on-off switch at the head end. e. Receivers must be properly balanced in order to minimize the possibility of channel bleed-over. f. Any additional equipment required in order to maintain the required channel selection due to signal change, changes in technology, etc., shall be the responsibility of the contractor. g. The head end rooms at the Department are air conditioned to the building settings. Any additional cooling requirements to properly maintain the equipment (i.e. rack fans) are the responsibility of the contractor, and must be per industry standards and NEC 2011 requirements.