Specifications include, but are not limited to: • Polyvinyl chloride (PVC) pipe and fittings shall be blue or white un-plasticized PVC plastic pressure pipe with integral bell and spigot joints for the conveyance of water. • This pipe shall meet the requirements of AWWA Standard C900, “Polyvinyl Chloride (PVC) Water Distribution Pipe” and shall be manufactured by J-M Manufacturing Company or approved equal. • All pipe shall be suitable for use as pressure conduit. • The bell shall consist of an integral wall section with a factory installed, solid cross-section elastomeric gasket, which meets the requirements of ASTM F477. The bell section shall be designed to be at least as hydrostatically strong as the pipe barrel and meet the requirements of AWWA C900. • The joint design shall meet the requirements of ASTM D3139. • Pipe shall be DR18, and pressure rating shall be a minimum of 235 pounds per square inch (PSI). • All bolts, nuts, washers, and other fastening devices shall be designed for use in corrosive service environments. All fastening devices shall be Type 316 stainless steel and conform to ASTM F 593 and ASTM F 594 standards.