Specifications include, but are not limited to: The contractor shall provide a mobile form, automatic pump, continuous fill/seal packaging machine and accessories for the Department of Corrections (hereinafter referred to as the state agency) in accordance with the provisions and requirements stated herein. General Description: The mobile form/automatic pump/continuous fill/seal packaging machine (hereinafter referred to as “equipment”) shall include a vertical form-fil-seal that forms a flexible pouch that uses film roll and heat seals the lapped vertical edges, fills, then closes the pouch with a final horizontal heat seal with built-in handle. The equipment shall produce pouches from 2 oz. to over 3 gallons and readily accommodate wet products. The volumetric filing shall be accomplished by an onboard, highly accurate, repeatable and gentle piston pump. Certification: The equipment shall be ANSI/UL-197 and NSF/ANSI 4-2007e certified. Construction: The equipment shall be of all stainless-steel construction with no clutches or brakes, allow for quick changeover between pouch sizes, and Lexan front and side guards for a higher level of impact resistance and tolerance of temperatures up to 240 degrees. 1) At maximum, the equipment shall have clearances as follows: Right side, 36” (+/- 2”) Back side, 36” (+/- 2”) Left side, 24” (+/-2”) The equipment shall have a removable conveyer and shall be no more than 43.6” wide. The equipment with conveyer shall be no more than 60.8” long.