Specifications include, but are not limited to: The tables are to be a width of 60 inches, depth of 22 inches and a height of 30 inches. They are to have power that is daisy-chained from table to table. They are to flip and nest for storage. They are to have casters for easy movement. Table Tops: The tops are to be 60” wide x 22” deep x 1.25” thick. They are to be a laminate work surface with a laminate backer sheet with a 3mm PVC edge. The laminate color and edge color are to be selected from the manufacturer’s standard offering. The grommet hole is to be located in the front center of the surface and shall not interfere with the table mechanism or interfere with the ability to flip and/or nest. Table tops shall be numbered underneath and numbers are easily recognizable for table placement in the room Table Base: The base is a 2.50” dia. hollow steel tube frame manufactured with .10” T cold roll powder coated metal. The color is to be selected from the manufacturer’s standard offering. The casters are 3.0” in diameter, double wheeled and have a minimum of two (2) locking casters and designed for carpet. The flip mechanism is steel and has two release paddles. Either paddle will release the table. When the table is down, it is locked until the paddle is activated. When the table is up, it is locked until the paddle is activated. The table top flips up and away from the user. Due to the depth of the surfaces, a modesty panel is not required and tables with modesty panels are not acceptable. Table Electrical: Basis of Design (ECA Villa Power Module) The electrical unit must contain two power outlets and two 21. AMP USB outlets. The USB outlets are for charging small electronics. Unless otherwise stated on the drawing, each table row is to have one infeed that provides power to the entire row. One power infeed must be able to support up to and not more than (6) six tables. The unit is to be mounted in the table grommet. Due to the multi-use nature of the tables, edge clamped units are not acceptable. The unit is to have a flip up door that conceals the power and USB outlets. Due to the multi-purpose use of this table, the flip-up door is to be flush with the table surface and shall only have a open slot to raise the door. Raised edges for lifting the flip-up door is not acceptable. Both the unit and grommet cover are to be securely fastened to the table top. All cords are to be secured to the table and not to be easily accessible to the user. The cords shall be easily accessible by the staff to allow easy connection and disconnection when storing and setting up tables. Cord shall not be seen when the tables are in the down position. The color is to be selected from the manufacturer’s standard offering.