Specifications include, but are not limited to: STANDARD DESIGN: Outboard Motor Style 2019 OR NEWER MODEL YEAR HULL MATERIAL: 0.100 gauge, marine grade aluminum bottom and sides. CONSTRUCTION: Welded HULL DESIGN: Tunnel Hull BOW DESIGN: Flat Bow LENGTH: Minimum 17’ BEAM WIDTH: Maximum 72” BOTTOM WIDTH: Minimum 52” inside floor width. TRANSOM HEIGHT: Compatible with a 60/40 HP Jet Mercury. SIDE HEIGHT: Minimum 22” from floor of boat to top of the sides. TRANSOM: Must be all aluminum and designed to support a 60/40 HP Jet Mercury Outboard Motor. FRONT DECK: Minimum 40” wash out deck. Front deck must be covered in non-slip paint. FUEL TANK: 6.6 Gallon Portable. FLOOR: Minimum 52” Wide. Perforated (minimum 0.100” thick, marine-grade) aluminum floor made to fit and secured in place. Must have open floor design. ICE RUNNERS: None CONSOLE: None. SEATS: Three (3) removable swivel seats and two (2) removable adjustable posts. One pedestal base mounted on Box #1 and one pedestal base mounted on the front deck. A rear foam filled bench seat the entire width of the boat with three (3) pedestal base mounted evenly across. STORAGE: The boat shall include four (4) dry storage boxes. See attached drawing for locations. See below specifications for measurements. All dry storage boxes must be painted in non-slip paint. REAR DECK: Aluminum hinged access door across the entire rear of the boat to store fuel tank and batteries. Lid must be painted in non-skid paint. MOTOR RATING: Minimum 60 HP. DRAIN PLUGS: Standard to manufacturer. TIE DOWN RING: Heavy-duty and bow and stern mounted. PAINT COLOR: Inside: Olive Drab Green Outside: Olive Drab Green RUNNING LIGHTS: Must meet U.S. Coast Guard requirements. Bow and stern lights must be removable post style lights. Bases must be installed with concealed wiring. Switch for lights to be mounted below the driver’s seat. STORAGE BOXES: Four (4) aluminum waterproof dry storage boxes covered in non-slip paint and must be installed according to attached drawing. Box #1: Passenger Seat. Minimum 36” long x 18” wide x 15” tall with a locking lid and latch attached, hinged in the rear, and mounted 26” behind Box #3 on the left side of the boat and running parallel with the boat. Box #2: Rod Box. Minimum 6’ 6” long x 18” wide x15” tall with a locking lid and latch attached, hinged in the rear, and mounted parallel to the boat on the right side directly behind the front deck. Box #3: Dry Storage. Minimum 36” long x 18” wide x 15” tall with a locking lid and latch attached, hinged in the rear, and mounted directly behind the deck on the left side of the boat running perpendicular to the boat. Box #4: Dry Storage. Minimum 18” wide x 16” long x 15” tall with a locking lid and latch attached, hinged in the rear, and mounted directly behind box #2. ACCESSORIES: Must include all the following at a minimum and mounted so they don’t interfere with steering wheel installation: Automatic bilge pump with a manual and automatic switch that is mounted below the driver’s seat. Two (2) electric switches for future hookup of lights and sirens mounted below the driver’s seat. 70 lb thrust trolling motor mounted and wired on the front deck with wires ran to box #3. COMPATIBILITY: All parts must be compatible with a Mercury Jet 40ELPT Fourstroke motor. PARTS: The boat must be equipped with all necessary parts for easy mounting and operation. WARRANTY: Minimum one (1) years on parts and labor.