Specifications include, but are not limited to: Design work may include, but is not limited to the following: Confirming existing conditions and previous predesign/schematic design documents, existing roof tear-off and replacement with a Minnesota State-approved roof system, mechanical work to replace and/or reconfigure roof drainage systems if necessary to meet codes and Minnesota State Facilities Design Standards, raise mechanical units to accommodate minimum base flashing heights, relocate and/or modify associated mechanical piping and electrical conduits as required, review existing roof design to determine if existing structures meet current building codes replace and/or patch existing metal deck as required, replace roof hatches and add/or modify roof access ladders, replace existing wall panels provide full time roof observation during construction. Roof Observers shall have a thorough knowledge of roofing details, flashing, and roof and building systems and shall ensure conformance with the design documents. On a daily basis, the Roof Observer shall consider weather conditions to determine which days are roof working days, shall check night seals, drain edges, and penetrations for water tightness every night before leaving job site, and provide daily roof reports on work progress and any issues found. Firm shall have roofing specific testing capabilities either in-house or through an outside certified testing lab, which will guarantee test results within 48 hours of submittal.