Specifications include, but are not limited to: All material used shall conform to AASHTO M 181 except as noted herein. The fence fabric shall be Type II - Aluminum Coated Steel or Type IV -- Polyvinyl Chloride (PVC) - Coated Steel. All tubular posts and rails, and roll-formed "C" section posts and rails shall be zinc coated steel. All wire shall have a diameter tolerance of ± 0.005 inches diameter. Spring tension wire shall be aluminum coated steel. Post caps, rail end and other fittings and appurtenances shall be pressed steel or malleable iron. All materials shall be new and undamaged when installed. Imperfectly coated materials will be rejected. Bonded Vinyl Coated Chain Link Fences, Posts, Rails, Fabric, Gates and Accessories. The fence shall have a bonded polyvinyl chloride (PVC) coating over aluminum coated or galvanized steel.. Polyvinyl chloride coated by dipping, thermal fusion or any other method that meets the requirements of this specification. The fence fabric shall be PVC coated wire that is woven into a 2 inch (50 mm) diamond mesh. The coating shall not crack, craze, or peel. The color of the PVC coated fabric and accessories shall be black. Posts Steel round pipe posts and "C" sections shall have a tolerance of ±10% from specified weight and ±5% from specified dimensions. Type B round pipe shall conform to AASHTO A 1011. Top Rail and Spring Tension Wire Rail shall have a tolerance of ±10% from specified weight and ± 5% from specified dimensions. Steel top rails shall be Type B 1.66 inch O.D. tubular pipe with a weight of 1.83 pounds per foot, or 1.625 x 1.25 inch roll-formed "C" section with a weight of 1.40 pounds per foot. The protective coating for top rails shall meet the requirements of paragraph B above. Couplings or expansion sleeves shall be outside sleeve type and at least six inches long. 2) Spring tension wire shall be coil spring steel 7 gage (0.177 inch). The base metal shall have a minimum breaking strength of 1,950 pounds coated with aluminum applied at a rate of not less than 0.40 ounces per square foot of surface area. 1. Contractor shall remove and properly dispose of existing fence around the entire perimeter of the cemetery. 2. Install approximately 4,250 feet of new 4’ tall, black, 6-gauge 2” wire chain link fence with related posts and rails as technically specified in this IFB. 3. Install pedestrian gates at all existing openings.