Specifications include, but are not limited to: This open-ended, on-call Contract consists of providing maintenance and repairs for any Administration street lighting at various locations. The work may include, but is not limited to, repairs to highway street lighting, exterior facility lighting, overhead sign lighting, bridge lighting, cable designation, cable fault locating and pole replacement, as well as maintenance of traffic to perform the repairs and may or may not be on a continual basis. If applicable, the limits of this Contract work may extend to the other maintenance shops within this District, should extenuating circumstances dictate the need, as mutually agreed upon by both the Administration and the Contractor. Replace fuse at base of pole. Replace fuse kit at base of pole. Replace line or neutral connector kit. Replace twin wire inside pole, bypass hand switch at top of pole. Replace wiring within inter-luminaire conduit or weather-tite flexible armoured conduit. Replace inter-luminaire weather-tite flexible armoured conduit, wiring and fittings. Replace above ground fuse. Replace bulb. Replace luminaire. Replace luminaire glassware. Replace loose connection. Remove defective fixture only. Install fixture only (old unit removed previously). Replace street light poles. Replace fixtures. Replace bases. Locating and repairing (including splicing) of underground electric street light cables. Replace equipment control and service entrance equipment. Maintenance of vegetation around lighting components Write daily report of work accomplished.