Specifications include, but are not limited to: 1. Selective demolition of existing gates, readers, and all appendages. 2. Selective site demolition for fencing, paving, and retaining wall. 3. Provision of new perimeter security fencing. 4. Provision of bituminous paving and retaining wall for truck turn-around. 5. Provision of bituminous paving for connector road from existing rear road to south parking area. 6. Provision of electric slide gates and traffic barrier arm. 7. Provision of single and double leaf gates. 8. Provision of covered exterior metal stairs with concrete slabs helical piers to the existing roof. At beginning of project mobilization, provide test pits at existing building walls, near proposed helical piers for stairs, to determine extent of the existing footings to make sure there is no conflict with these helical piers. If there is a conflict, issue RFI immediately for direction. The digging of these test pits shall be performed early enough to not impact project schedule. 9. Provision of pole mounted LED site lighting fixtures. 10. Provision of covered stair lighting. 11. Provision of pole mounted and wall mounted cameras. The CCDC shall be responsible for programming the feed into the surveillance system. 12. Provision of intercom and card reader conduits to existing control room. Temporarily remove existing ceilings as required for above ceiling access. The CCDC shall be responsible for wiring and programming into their system.