Specifications include, but are not limited to: A. Pump shall be pulled by the contractor at the pump site location. Pump repair contractor shall be required to supervise and assist in pump pulling (pick-up), and loading on a truck to be delivered to contractor's shop. Pump is to be delivered to the repair shop by the pump repair contractor using his own vehicle and personnel at no additional cost to the Parish. NOTE: Contractor will furnish all required labor, tools and equipment, cranes, slings, etc. necessary to lift/lower pump during its removal/installation at pump site, and load/unload pump onto/from contractor’s transport truck. B. Contractor shall disassemble the pump in his shop or on the pump site and thoroughly clean all parts by chemical means, sand, bead, or shot blasting. Care must be taken to prevent damage to finely finished surface during cleaning. Contractor shall check all components for wear clearances, erosion, or any other changes that might be detrimental to safe and reliable operation. Any problems found must be included in the submitted report. Disassembly is to be accomplished in accordance with the manufacturer's recommendations.