Specifications include, but are not limited to: The contractor shall provide bus vehicle wraps with the substrate material of Vinyl 3M 180 CV3 with Laminate 8518 Lusterlam or an approved equal. Refer to Attachment PDF 1 for Wrap Design Artwork. Measurements for the Ford Aerotech 240 vehicle (with a 36” door) can also be found in Attachment PDF 1. The contractor shall be responsible to verify the vehicle measurements are accurate prior to production of the wrap (e.g., the Contractor shall measure the vehicle for proper fit for the wrap and make any adjustments needed to the Artwork to have it properly fit the vehicle. However, the contractor shall consult with the KCATA Marketing Department of any adjustments/changes needed prior to production to get the KCATA Marketing Departments written approval on such changes). Wrap will need to wrap over the top edges with a 17” roll over on the roof top; however, the front top cap that is located above the front door and extends over the windshield shall require the entire cap to be wrapped completely.