Specifications include, but are not limited to: A – Tank 50-gallon capacity L shape polypropylene water tank skid unit. The tank shall be constructed of ½” black, textured, UV resistant polypropylene material with a ¾” thick pump platform. It shall be baffled with minimum 3/8” transverse and longitudinal baffles to meet NFPA standards and shall include a full lifetime factory warranty. Made in the USA. The tank shall be approximately 35” Long x 47” Wide x 15” High and fit in a 4x4 825 I John Deere Gator UTV with tailgate closed. The entire skid unit, including the hose reel, shall be approximately 35” Long x 47” Wide x 35” High. The tank, at a minimum shall include the following: White plastic sight gauge located on the driver side rear. Lo-profile 5” minimum diameter tank fill/vent. The driver’s side tank top shall have an additional ¾” thick polypropylene mounting plate. 1” diameter FNPT fill port 1 ½” diameter FNPT Tank Suction shall be internally plumbed to the dead center of the tank and then elbowed down to provide for maximum water usage at any slope off road. 2” Diameter FNPT drain Front and rear mounting tabs B – Pump Mounting The Wick water pump shall be mounted on the passenger-side rear tank platform in such a way that it deflects the engine noise away from the operator of the UTV and is quickly removable using only a spanner wrench, for optimal use as a portable pump in remote draft sites. C – Pump Wick 80-4H Single stage pressure pump powered by a 1.5Hp Honda Max Weight: 18 lbs. Engine: 1.5 HP, 4 Stroke, Air-cooled. Recoil-start Honda Integral Fuel tank