Specifications include, but are not limited to: • All work to be done during normal business hours 6:30am-4:00pm Mon- Fri. After hours are available with prior approval. • Remove current downspouts and gutters for contractor’s disposal off site. • Provide and install new hardware, downspouts and gutters as per plans. • Current areas listed have no gutters, but DOT would like them added and tied into the one below on the same side. (See photos 5, 6 and 7) • Photo six is the second story roofline. DOT would like gutters installed there also and tied into existing. • On the North side of building, or areas where it dumps on landscape we would like pivot points for the downspouts to be lifted for mowing or maintenance. • Verify above listed work is per local codes. • Any additional items or parts found defective need approval prior to completing. • Contractor to have a minimum of a 1-year warranty on all parts and labor. A. Sheet Metal Flashing and Trim Manufacturers: 1. McElroy Metal; www.mcelroymetal.com. 2. Petersen Aluminum Corporation: www.pac-clad.com/sle. 3. Substitutions: See Section 01 6000 - Product Requirements. 2.02 SHEET MATERIALS A. Pre-Finished Galvanized Steel: ASTM A653/A653M, with G90/Z275 zinc coating; minimum 24 gage, (0.0239) inch thick base metal, shop pre-coated with PVDF coating. 1. PVDF (Polyvinylidene Fluoride) Coating: Superior Performance Organic Finish, AAMA 2605; multiple coat, thermally cured fluoropolymer finish system. 2. Color: To match existing adjacent materials