Specifications include, but are not limited to: 1. Trailer Bed Approximately 20’ flatbed trailer with a 5 foot tail, wood floor mounted to steel cross members and framing. Beavertail shall have center flip-up Steel I-beam frame construction, 12” 19 lb I beam, angle is acceptable, Cross members on 16” centers 2 spring assist stand up ramps, 5’ flip up ramps, 18” wide with adjustable leg Trailer deck to have 3” steel side rails, rub and stake pockets Front rail, 8” tall, 3/16” sheet front rail 2. Trailer (General) GVWR 20,000 lbs Furnished with 3/8” safety chains and hooks Floor – pressure treated 2’ x 8” wood plank floor. Flooring shall be firmly attached to all cross members, side and end rails. Electric brake(s) Spring suspension Safety Reflective Marker Tape Red/White running the length of both sides of trailer Oval reflectors mounted as follows: Right front side-one amber Left front side-one amber Right rear side-one red Left rear side-one red Dual drop leg heavy duty spring loaded jack Pallet fork holders Mud flaps 2 – 5/16” adjustable gooseneck Weather tight registration holder mounted to inner frame rail on trailer tongue All trailer wiring must be soldered and shrink wrapped; scotch-loc or wire nut securement is not acceptable (8) Frame mounted D ring tie down points. Mounted as follows: Right/Left front corners of trailer deck Right/Left rear corners of trailer deck Right/Left sides approximately 8’ from rear Right/Left sides approximately 8’ from front 3. Wheels/Tires Two 10,000# Heavy Duty oil bath axles Dual ST235-80R-16E tire and wheels 4. Brakes 12 V Electric breakaway kit with lockable box, switch, and rechargeable battery Self-adjusting brakes, both axles 5. Lights D.O.T. Stop, Tail, Turn and Clearance lights rubber mounted and sealed LED (must be compliant with State and federal DOT requirements) 7 flat pin trailer light and controller connector