Specifications include, but are not limited to: 1. Provide all labor, tools, and materials needed to remove and replace existing siding with aluminum siding. 2. It is the Contractor’s responsibility to take the time to walk around the building and mark walls so as to start at the lowest elevation. 3. All measurements and scope of work must be verified on the job. 4. Use metal or solid non-flexible material to start the first course of siding. 5. Siding shall be of proper gauge in accordance with manufacturer’s specifications. 6. Contractor shall use minimum 3/8” insulation board. 7. Nails shall be aluminum type, length and spacing of all nails must be in full accordance with siding manufacturer’s installation specification. Steel or galvanized nails are not acceptable. 8. Matching continuous 1-1/8” minimum corner posts shall be used. J-channel must be 1- 1/8” minimum to match siding. 9. All windows, doors and louver frames must be individually cased with trim. 10. Total edge of capping where butts siding, window and door area shall be caulked. Rubber base chalking shall be used and matched.