Specifications include, but are not limited to: 5.2 These panels will be outfitted with dual sided projection film. The projection film shall not contain any lead or metallic products. The approved manufacturer for the projection film is Pro Display, model is 360 Film. 5.3 It is pertinent that the specialty glazier does not use suction cups to handle or install the glass panels after any projection or touch film has been applied. Failure to comply with these specifications noted above will result in a poor interactive experience. 5.4 The touch film shall be applied to the backside of the glass panels and be capable of producing at least 20 points of touch, per instance. The approved manufacturer for the touch film is Displax. 5.5 The touch information shall be transmitted back to the AV headend via USB extension over CAT6 cabling. It is the responsibility of the AV Integrator to test and verify that touch information from the touch film to the headend PC’s is functioning as intended. Touch information to Boise State University PC’s will be handled by Downstream custom middleware. Cabling shall be concealed in a custom header with a j‐box and conduit extending back to the AV headend. The AV contractor shall sub‐contract a specialty fabrication firm to complete the header as detailed in the environmental design deck.