Specifications include, but are not limited to: SECTION 1: CONCRETE A. Batting Cages Size: (2) concrete areas - 15’x70’ each cage (end to end) or 30’ x 70” (side by side) Concrete: a. 4” slab of 3000 psi concrete b. 1” slope for every 10’ toward each end of court c. Expansion Joints: use 0.5” (12mm) Saw Cut d. Rebar- ½” steel rebar placed in both direction, tied, 24” center e. Surface finish = Heavy Broom f. Edge finish = Straight g. Concrete 1” above ground surface maximum h. Structure outside the pad – Sufficient Backfill Material must be prepared to support footings for court components i. CAGE Components are located inside the pad, anchors and or ground sleeves must be placed in the pad prior to pouring cement ALSO Frames layout in concrete before pouring B. Basketball court – Outdoor a. Concrete are -- Size 50’ by 100’ b. Concrete 1” above ground surface maximum c. 4” slab of 3000 psi concrete d. 1” slope for every 10’ toward each end of court e. Expansion Joints: use 0.5” (12mm) Saw Cut f. Rebar- ½” steel rebar placed in both direction, tied, 24” center g. Surface finish = Medium Broom h. Edge finish = Straight i. Structure outside the pad – Sufficient Backfill Material must be prepared to support footings for court components j. GOAL TO BE INSTALLED OUTSIDE OF COURT IN CONCRETE SECTION 2: OUTDOOR BASKETBALL COURT FINISH Basketball court – Outdoor – finishes with lines a. Court need to cure for at least 30 days b. Etch concrete with muriatic acid c. Then surface binder d. 2 coat of color coating e. Paint lines (EXACT SIZE TO BE DETERMINED PRIOR TO SECTION 2 WORK)