Specifications include, but are not limited to: A. Stormwater Infrastructure and Drainage Improvement Contractor design services may include all or some of the following: Hydraulic analysis or modeling for new or replacement culverts, Stormwater pipe/drainage design Green infrastructure/low impact development BMP design Stormwater management facility design, open channel design, stream bank restoration, environmental design services (i.e. life cycle analysis, Master Planning, stream monitoring or impaired stream watershed improvement projects) Stormwater best management practices design Development of concept plans, base mapping/surveying data, engineering reports, construction plans, construction documents, erosion and sediment control plans, quantities, right‐of‐way plans, permitting, cost estimates, bid documents, etc. Additional services could include professional opinions, plan review, MS4 reporting and compliance, and bid‐phase services. B. Construction and Project Management The Contractor shall provide the following services: Provide project management and construction management services for the City’s capital projects relevant to Stormwater Management and Transportation. This means to coordinate and make recommendations to the city on an annual basis regarding future capital program requirements, including the scheduling of capital program projects. Communicate the future capital needs of the City to the designated City representative. With regard to all projects, comply with all reporting requirements of local, state and federal laws.