Specifications include, but are not limited to: 1. Wall Surround System shall be ACRYLIC by DELTA, AMERICA STANDARD, STERLING or approved equal by the (OCD); accessories shall include soap dish and shampoo holder; surface mounted. Product selection by the homeowners, not to exceed $325.00. 2. The wall surround system members shall not be less than .093 inch thick as manufactured. Assembly shall be three (3) piece direct-to-stud section pieces, designed to interlock and seal. Surround shall be customized to meet the specific dimensions of the pre-existing tub and surround areas. As noted, an alternative method of assembly, installation and configuration may be used if approved by the [Office of Community Development and Homeowners]. 3. Tear out/demo bathtub surround and drywall from studs to a clean, smooth finish without defects, ready to accept tub and surround. 4. Remove plumbing bathtub faucet handle(s) and chrome plate, bathtub spout, drain, bath overflow assembly, and wall mounted hand-held shower head on slide bar. Shower unit shall consist of a spray unit with a hose at least 60” inches long that can be used as a fixed shower head and as a hand-held shower unit. Thereafter, install same finished plumbing fixtures of the same size, fittings and type of threads to fit all openings. Product(s) by KOHLER, DELTA, AMERICA STANDARD or approved equal by the (OCD). 5. Remove and legally dispose of any piping not necessary to rehabilitate tub. Disconnect waste/drain lines, overflow and bath drain shoe, P-trap, apron, caulking and other impediments; thereafter, remove tub and legally dispose of same.