Specifications include, but are not limited to: 1. This project consists of the replacement of existing roofing. This project will generally consist of the removal of roofing and the installation of new 30-year dimensional shingles. Including paying for all fees and permits, all labor, tools, equipment, transportation and services required to furnish and properly install all finishes as required, but not necessarily limited to supplying labor and equipment necessary for the specific work as listed below. 2. Furnish and install all Labor Material as required for the complete replacement of the roofing system. 3. Provide and install Architectural, large tab design, granule surfaced, self-sealing asphalt shingle with a strong fiberglass reinforced Micro Weave core and Stain Guard protection GAF/ELK 30 high definition shingles or per-approved equal 4. Provide and install #15 roofing underlayment: Water repellent breather type cellulose fiber building paper. Meets or exceeds the requirements of ASTM D 4869 Type I 5. Provide and install 24-gauge valley flashing and drip edge (rakes & eaves) prefinished color to match roofing. 6. Provide and install distinctive self-sealing hip and ridge cap shingle complementing the color of selected roof shingle. 7. The contractor shall be responsible for the protection of materials against damages until accepted by owner. 8. Provide a unit cost to replace a full sheet of sheathing. Contractor shall request a roof inspection with Housing Authority staff to determine number of sheetsto be replaced, if any.