Specifications include, but are not limited to: 1. Main Office, 405 U Street: A. Building A: • Re-move existing outside door camera and move further out to capture outside activity. • Relocate keypad from south entrance to breakroom entrance. • Install 1, 360° view camera inside file room. • Install 1, 360° view camera outside of file room, facing Lesher & George Drive. • Install 1, 360° view camera outside of door facing parking area. B. Building B: • Replace the duct alarm sensor system throughout Building B. • Building B Lower Level: ❖ Install new door sensor to side garage door. Connect sensor alarm to existing door sensor connection at Building B lobby entrance. All of Building B doors shall be connected to the same alarm system. ❖ Install 1, 360° view camera on the inside corner of Maintenance Vehicle Parking Garage. ❖ Install 1, 360° view camera at the corner of the training room and the locker room. • Building B Upper Level: ❖ Install, 360° view camera at the corner of the break room and bathroom 2. Camera should capture all hallway activity in both directions. ❖ Install, 360° view camera at the corner of Finance office and office of Development Tech. Camera should capture all hallway activity in both directions. C. Building C (400 West Avenue): • Install 1, 360° view camera at the porch entrance to face West Avenue. • Install 1, Inside facing camera to capture hallway activity above the door leading to the parking area. D. Building D: • Currently Building D has two separate alarm systems. The contractor will connect all sensors of Building D to be on the same alarm system. • Install 1, 360° view camera, camera position should be at an angle to capture door and garage door activity without obstruction. • Install 1, 360° view camera at storage door facing storage area. • Install 1, 360° view camera camera position should be at an angle to capture door and garage door activity without obstruction. E. Building E: • Install 1, 360° view camera facing out towards Lesher Drive. 2. O’banion Learning Center, 401 Lesher Drive: A. Replace the duct alarm sensor system at 401 Lesher Drive. 3. AMP 1, 23-13 McDowell Manor, 2858 Park Avenue: A. Install 1, 360° view camera located at the discretion of contractor. Outside cameras must have bulletproof protective housing. 4. AMP 2, 23-06 1005 8th Street, Livingston Office and open area lightpost: A. Install door sensor in Livingston Office shop/garage B. Install 1, 360° view camera that will capture all door entrances. C. Install 1, 360° view camera on lightpost on the open yard lightpost. Outside cameras must have bulletproof protective housing. 5. AMP 2, 23-12A 2870 Crest Road Office: A. Re-position existing lobby camera to capture front door activity. B. Install 1, 360° view camera to capture all activity.
