Specifications include, but are not limited to: A. Gates shall be as specified herein. B. The gate shall utilize self-adjusting seals C. All structural components of the frame and slide shall be fabricated of stainless steel having a minimum thickness of 1/4-inch and shall have adequate strength to prevent distortion during normal handling, during installation and while in service. D. All welds shall be full and continuous performed by welders with AWS certification. E. Finish: Mill finish on stainless steel. Welds shall be sandblasted to remove weld burn and scale, pickled & passivated. All iron and steel components shall be properly prepared and shop coated with a primer. GATES A. Three (3) 188” (w) 31” (h) Stainless Steel Weir Gates; Rectangular Opening; Wall Mounted; Design Head – up to slide height; Sealing on bottom and sides (No Top Seal); Installation Depth – 5.1ft; Operator – Pedestal Mounted Manual Actuator, Type of Closure – Conventional Bottom, Stem Extension - Dual Rising Stems with Covers; Open top Frame Configuration; Downward Opening. B. Two (2) 152” (w) x 31” (h) Stainless Steel Weir Gates; Rectangular Opening; Wall Mounted; Design Head – up to slide height; Sealing on bottom and sides (No Top Seal); Installation depth – 5.1ft; Operator – Pedestal Mounted Manual Actuator; Type of Closure – Conventional Bottom; Stem Extension Rising with Stem Cover; Open Top Frame Configuration; Downward Opening. C. Bidder is responsible for verifying all dimensions and confirming that gates being bid will install with existing equipment properly.