Specifications include, but are not limited to: All areas of the parking surface must be cleaned and prepared for sealing. Some areas of the vehicle parking surface require Hot Asphalt patch work. The total area should not exceed 3 ton of material. This application will require compacting with vibration drum rollers or tampers. Further preparation of the surface is crack sealing. All cracks ΒΌβ and wider shall be cleaned out and a Hot Rubberized crack sealant used to fill the voids. Any cracks larger than 4β wide shall be cut and a hot Asphalt patch applied for the entire length of it. Petroleum stains and saturated areas shall be cleaned and treated with a Polymeric Primer for better adhesion. A machine application of a minimum of two coats of Sealmaster MTR Sealer, or better, to asphalt surfaces. Contractor shall take measures to ensure traffic is limited to the work area. Parking stripes and Handicapped Parking marked areas shall be repainted with the current configuration. Taxi lines and any other airport markings shall be reapplied as needed. All paint markings shall have a reflective media (Silica) applied.