Specifications include, but are not limited to: Two submersible non-clog pumps, rated to deliver 200 GPM @ 28' TDH. The control and electrical cables shall be 50 feet long, and all applicable control relays and complete guiderail system shall be included in quote. It will be the vendor's responsibility to make a site visit to assure their equipment that requires depth and dimension measurements meet the need ofthe scope of work. Capability: 3" minimum diameter spherical solid passage. Materials of Construction: 1. Casing - Cast Iron A48 Class 3SC or 40 2. All Exposed Bolts and Nuts - 316 Stainless Steel 3. Pump Exterior Coating Factory applied primer and finish coat to suit pumped media 4. Pump Interior and Base Elbow Interior Coating - All internal wetted parts including volute assembly, impeller and discharge connection shall receive a ceramic-epoxy coating as per below . • Belzona® 1321 (Ceramic S-Metal) (Minimum 24 dry mils thickness) shall be applied blue topcoat and gray basecoat (to ensure successful overlap) by brush, applicator, or spray at a typical thickness of 15 mils per coat. The first coat shall not be left more than 24 hours before overcoating with the second coat. Evidence of basecoat shall not be identifiable upon completion. 5. Shaft and Sleeve - Stainless Steel AISI 431 or 420 6. Impeller - Grey cast iron ASTM A-48 Class 3sB; the impeller shall not be a Vortex style . • When required per spec - Hard Iron (ASTM A-532 (Alloy ll1A) 25% chrome cast iron. And shall have hard iron wear ring or wear plate with equal hardness to the impeller. 7. O-Rings - Viton 8. Upper Bearing - Single row deep groove ball bearing 9. Lower Bearing - Two row angular contact ball bearing;