Specifications include, but are not limited to: 1.Coordinate work schedule with Owner'srepresentative.2.Check the general operation of the escalator. Adjust and lubricate the components, including, but not limited to, the items listed below:a.All control system components. All drive machine components. Drain and flush the gear case as needed to remove sediment and grit. Refill with new oil.b.Allcontrolwiringandallpowerwiringfromtheequipmentinputterminalstothe motor. All handrail and all handrail drivecomponents.c.Missing step detector, handrail speed detector, handrail inlet switches, step up thrust inlet switches, combplate impact device, skirt switches, pit and motor stop switches, access cover switches, out-of-level step switches, emergency stop and inspection switches, alarm on the stop switch cover, broken step chain switches, key start switches, and brake temperatureswitch.d.All step chains, guidancesand alignment components and demarcation lights. Balustrades and decks shall be examined and aligned, adjusted and fastened as needed.e.All inspections and preventative maintenance will conform to manufacturer’s recommendations.3.No additional charges will be accepted during the term of this Agreement without City’s approval. This includes any need parts and/or technical services.4.The inspections and preventative maintenance work is to be performed on a quarterly basis during the term of this Agreement in coordination with the Contract Services Administrator.5.Service Contractor shall make all required repairs and/or replace all defective components listed above at no charge to the Owner. No additional charges will be accepted during the term of this Agreement without City’s approval. This includes any needed parts and/or technical services.