Specifications include, but are not limited to: 1.All turf areas will be mowed weekly during growing season (approximately March-October).2.All turf areas will be mowed once a month during winter months, or as needed.3.All turf areas will be mowed at a consistent, appropriate height (determined by UAH Grounds leadership and contractor) to promote healthy turfgrass and achieve an aesthetically pleasing appearance.4.Mowing frequency and/or mowing height may need to be adjusted during seasons of drought or stress. Any adjustments will be agreed upon and communicated with UAH Grounds leadership prior to implementation. 5.All trash and limbs on property (in turfgrass, beds, sidewalks, hardscapes, etc.) will be picked up priorto mowing. 6.Contractor will use the proper mowing equipment to achieve a high-quality cut and prevent scalping and/or rutting.7.Where possible, contractor is expected to vary mowing patterns to promote healthy turfgrass and prevent rutting.8.Contractor will deposit and leave turf clippings on lawn areas with the exception that this will create a large surface buildup. In the case where a mower leaves excessive clippings (rows), the contractor will collect and remove these clippings from the job site at theend of each visit. Clippings will not be left overnight.9.Permanent fixtures such as parking signs, light poles, etc. will be maintained weekly with weed trimmers at a height consistent with surrounding turfgrass. Care will be taken to prevent fixture, property, and grounds damage. Contractor is responsible to clean, repair and/or replace any property damaged by contractor’s operations. 10.Edging and trimming along curbs, walkways, and landscape beds will be performed weekly during growing season to maintain a neat and consistent appearance. All hard edging will be performed by mechanical stick-edgers (not weed trimmers). Any edging and/or trimming that cannot be performed during regular visits due to vehicle obstruction will be serviced after hours or on weekends when obstructions are not present.