Specifications include, but are not limited to: Furnish, install, and make operational a new 10-Ton heating and cooling system to service the RO Plant Server Room. Note that all selected heat pump and air handler components to be manufactured by the same manufacturer. Contractor to visit the site and obtain other information needed to prepare the bid including but not limited to room size, equipment heat load, cooling requirements, heating requirements, electrical power supply, duct routing, line routing and work environment. On going plant operations will take precedence over any installation activities. Close coordination with the Plant Manager and Mechanic Foreman is required. Components to include but are not limited to: 1. 1 Each – 10-ton Outdoor Dual Circuit Heat Pump 3 phase 460 volt; Trane TWA120044 or Approved Equal. 2. 1 Each – 10-ton Air Handler Dual Circuit 3 phase 460 volt; Trane TWE12044 or Approved Equal. 3. 1 Each - Air Handler installed Return Filter Grill; Trane BAYGRLE803 or Approved Equal. 4. 1 Each - Vertical Subbase for Air Handler; Trane BAYBASEO or Approved Equal. 5. 1 Each - 10 kw Auxiliary Heater 3 phase 460 volt or Approved Equal. 6. 1 Each - TCONT824 Wi-Fi Thermostat installation and set up or Approved Equal. 7. 2 Each - 1 3/8 and 1/2 Refrigerant line replacement or Approved Equal. 8. Reconnect to Existing drain line and high voltage electrical. 9. Modify existing duct work or modify existing as required to install system. 10. Make building modifications as required; (review with Plant staff) 11. Reuse existing concrete slab for heat pump. 12. Install controls. 13. Removal and disposal of old equipment. 14. Installation, wiring, start up, verify efficient operation and refrigerant charges.