Specifications include, but are not limited to: Seasonal Start-Up Service: (Complete April 15Th thru June 18th.) A. Startup and verify that the unit is operating within design parameters such as flow rates, temperatures, pressures, voltages, Amp Draw, etc. B. Verify proper operation of interlocking safety controls. C. Check refrigerant level, pressure and temperature. D. Check oil level, pressure and temperature. E. Check water flow pressure and temperature. E. Inspect oil sump temperature and heater operation. F. Check and test all operating and safety controls. G. Check all functions of the control panel. H. Check sensor signals to the control panel. I. Complete a detailed Start-up Operating Log when unit has stabilized. J. Review results of Start-up Log with operating personnel. Midseason Operating Inspections: (Complete July 1st thru August 15th.) A. Complete mid-summer operating inspections. B. Review Owner's Operating Log. C. Verify that the unit is operating within design parameters such as flow rates, temperatures, pressures, voltages, Amp Draw, etc. D. Verify proper operation of interlocking safety controls. E. Check refrigerant level, pressure and temperature. F. Check oil level, pressure and temperature. G. Check water flow pressure and temperature. I. Check and test all operating and safety controls. J. Check all functions of the control panel. K. Check sensor signals to the control panel; ALL REPAIR work must be pre-approved by the Regional Supervisor.