Specifications include, but are not limited to: The scope of services covered by this RFQ is to perform the tasks described in the Topographic Survey, Base Scope of Services. Proposing respondents shall retain a qualified underground utility location service to provide thorough data collection and facilitate completion of the work tasks listed below: 1. Note width of adjoining roadways, width and type of pavement. Identify existing landmarks and monuments; 2. Plot location of existing structures and corners on the property and structures on adjacent properties within 75 feet; 3. Locate and describe relevant features, including, but not limited to fences, power poles, light standards, signage, equipment, and walls; 4. Show recorded or otherwise known easements and rights‐of‐way; state the owner of right of each; 5. Note possibilities of prescriptive rights‐of‐way and the nature of each; 6. Establish a minimum of one permanent benchmark on site; description and elevation to nearest .01’. Location of benchmark to be determined by Architect of Record; 7. Indicate contours at one feet intervals; error shall not exceed one half contour interval; 8. Indicate spot elevations at each intersection of a 50 feet square grid covering the property; 9. Provide spot elevations at joint points and match lines where new pavement and/or structures will interface with existing surfaces and/or building finish floor, and roof elevations in the area of project construction; 10. Provide spot elevations at street or walkway intersections and at 25 feet on center on curb, sidewalk and edge of paving, including centerline and far side of street. If elevations vary from established grades, state established grades...